Introduction
Here’s what we’re all about: building industrial space heaters that just plain work. The kind that throw out serious, controllable infrared heat and keep going, day after day, even in the grit of a factory. We use halogen-filled quartz tubes to create that intense radiation, and we fit them with standard R7s end caps. That means installation is quick and repeatable. No mess. No fuss. Just a heater that’s clean to spec, easy to wire up, and built to run hard.
Technical Deep-Dive
These heaters are all about packing a lot of power into a small space. You’re looking at typical ratings of 2000–2500 W, with the ability to run on 400 V. That matches up perfectly with industrial electrical systems and keeps the current draw down. The tubes themselves are around 300 mm long, which concentrates all that heat into a specific zone. It gives you predictable, focused warmth right where you need it—whether you’re heating an enclosed area or warming up a piece of process equipment.
Material & Design
That quartz envelope is filled with halogen, which helps keep the filament temperature steady and extends the heater’s lifespan. We also add a reflective coating to the tube. It pushes more infrared energy forward, so you get better directional heating and less wasted output. And the R7s connector? It’s a secure, high-temperature interface that holds everything in alignment. When it’s time for a replacement, it’s a simple drop-in job. Seriously, it just works.
Application & Benefits
This setup is perfect when you need fast, radiant heat without warming up all the air around it. Think workshops, service bays, or any spot-heating job that needs to be precise. But here’s the thing—you’re dealing with serious heat density. So you have to plan your mounting location and ventilation carefully. That way, you keep components and anyone working nearby at a safe temperature. It’s powerful, so a little planning goes a long way.